Advertisement
Check the product and charger as well as accessories for damage
before each use. Do not use the product if it is damaged or shows
wear. Double check that the accessories and attachments are
properly fixed.
Always hold the product on its handle. Keep the handle dry to
ensure safe support.
Switch the product off immediately if you are disturbed while
working by other people entering the working area. Always let the
product come to complete stop before putting it down.
Do not overwork yourself. Take regular breaks to ensure you can
concentrate on the work and have full control over the product.
DRILLING
Set the mode adjustment ring to drilling mode when drilling into
wood, plastic or steel.
Always hold the product perpendicular to the point to be drilled.
Holding at an angle may cause slipping/jamming of the drill bit.
Always place the drill tip directly on the point to be drilled first
and then switch the product on.
Pre-drill larger holes with a small diameter drill bit first. Doing so
makes drilling with a larger diameter drill bit easier.
Do not always drill at top speed. This unnecessarily increases the
wear and tear of the product and drill bit.
Remove blocked and stuck drill bits by changing the rotational
direction.
On plastics and steel, punch the drilling point before operation in
order to avoid slipping of the drill.
Use suitable drill bit for drilling into plastic and steel.
GENERAL OPERATION
20
IBL BM18-60
Advertisement
