BASICS
Initial Setup
Power Up
Alarm Clock
Insert the 5V Power Adapter into an outlet, and then plug it into the Power Jack on the back
of the Alarm Clock. Next, remove the Insulation Tab from the Battery Compartment located on
the bottom of the Alarm Clock.
Thermo-Hygro (TH) Sensor
Install 2 fresh "AA" batteries according to polarity and replace battery cover. The blue LED light will
flash when transmitting.
Note:
It may take up to 10 minutes for your sensor data to appear on your Alarm
Clock's screen.
Back of Alarm Clock
Thermo-Hygro
Sensor
02