Safety Information - SAFEasy SF2 Series Instruction Manual

SF2 Series

1.4. Safety information

The following points must be observed for a correct and safe use of
TM
the SAFEasy safety device:
• The stopping system of the machine must be electrically controlled.
• This control system must be able to instantly stop the dangerous
movement of the machine during all the phases of the working cycle.
• Mounting and connection of the safety light curtain must only be
carried out by qualified personnel, according to the indications
included in the special sections (refer to sections 2; 3; 4; 5; 6).
• The safety light curtain must be securely placed in a particular
position so that access to the danger zone is not possible without the
interruption of the beams (see section 2 "Installation mode").
• The personnel operating in the dangerous area must be well trained
and must have adequate knowledge of all the operating procedures
of the safety light curtain.
• The TEST button must be located outside the protected area
because the operator must check the protected area during all the
Test and Reset operations.
Instruction Manual
6