Checking The Leds On The Spio; Spio Run/Fail Led States - Cisco ASR 5000 Installation Manual

Checking the LEDs on the SPIO

Checking the LEDs on the SPIO
Each SPIO is equipped with the following status LEDs:
• Run/Fail
• Active
• Standby
In addition to the LEDs listed above, each interface to the management network (both RJ-45 and SFP) are
equipped with the following LEDs:
• Link
• Activity
Figure 4: SPIO LED Locations
The possible states for all of the SPIO LEDs are described in the sections that follow.

SPIO Run/Fail LED States

The SPIO Run/Fail LED indicates the overall status of the card. This LED should be green for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
ASR 5000 System Administration Guide, StarOS Release 21.2
12
Troubleshooting