Additional Functions - PROFILO PSI21600 User Manual

The light will go off once the required
temperature is reached.
●
The iron is ready for use.
4 Press the Steam Burst Button – steam will burst from
the holes of the soleplate.
5 For stubborn wrinkles, wait a few seconds and press
Steam Burst button again.
Most wrinkles can be removed within three
presses.
It may be necessary to press the Steam Burst
Button a few times to engage this function.
For optimum steam quality, do not press the
Steam Burst Button more than three times after
the heater light goes off.
STEAM BURST IN VERTICAL POSITION
This function provides extra amount of steam for removing
creases from delicate fabrics in hanging position (hanging
curtains or other hanging fabrics).
The steam generated by the iron has very
high temperature. Never use the appliance for
ironing clothes or fabrics while they are being
worn by people or pets. Never aim the steam at
people or pets.
1 Proceed as described in the "Before First Use" section.
2 Turn the Temperature Dial to "●●●".
3 The Heater Light will come on.
The light will go off once the required
temperature is reached.
●
The iron is ready for use.
4 Hold the iron between 15 and 30 centimetres away from
the garment.
5 Press the Steam Burst Button - steam will shoot from
the holes of the soleplate.
6 For Stubborn wrinkles, wait a few seconds before
pressing the Steam Burst Button again.
Do not press the steam burst button when the
light is on. Additional steam can be generated
only when the light goes out.
Most wrinkles can be removed within three
presses.
It may be necessary to press the Steam Burst
Button several times to start this function.
For optimum steam quality, do not press the
Steam Burst Button more than three times in
a row.
PSI21600-001_v01
When ironing delicate fabrics (synthetics, silk,
velvet etc.), keep the iron a few centimetres
away from the garment to prevent damage.
ENDING THE IRONING
1 Turn the Temperature Dial counter-clockwise to "MIN"
position. The will turn off.
2 Set the steam control to
3 Unplug the unit.
4 Empty the water tank. See "Emptying The Water Tank".
5 When the iron has cooled completely, store it vertically in
a safe place.
Emptying The Water Tank
●
Set the Steam Control to
●
Unplug the unit.
1 Hold the iron upside down and shake it gently to remove
the remaining water.
2 When the soleplate is still hot, press the Steam Burst
Button to drain the water tank.
3 Press the Spray Button to release any remaining water.
●
Before storing the iron, make sure the Steam Control is
set to position.

Additional Functions

ANTI SCALE SYSTEM
The appliance has a build-in anti-limescale container.
It is designed to reduce the build-up of limescale which
occurs during steam ironing.
The build-in anti-scale cartridge prolongs
the service life of the iron. However, it will
not completely stop the natural process of
limescale build-up.
SELF CLEANING
This function provides for removal of scale and mineral
built-up in the Steam Chamber. The performance of the iron
largely depends on the water hardness and the frequency of
performing the self-cleaning process. It is recommended to
perform self-cleaning at least once a month or more regularly.
1 Fill the water tank as described in "Fill with water"
section. Fill the water tank halfway.
2 Place the iron in an upright position.
3 Connect the iron to a suitable power source.
4 Turn the Temperature Dial clockwise to "●●●".
5 Heater indicator light will come on.
The light will go off once the required
temperature is reached.
●
The iron is ready for use.
position.
C
position.
11