Toshiba dynadock 4K User Manual page 31

Using the dynadock 4K Docking Station and
The dynadock 4K docking station Max Output Resolution
and refresh rate are dependent on the number of displays
and the ports connected:
Number of Video
Ports Connected
Single
Single
Single
Dual Display
Dual Display
* The DisplayPort™ or the HDMI™ port only outputs in 4K (3840 x 2160) to a
single external monitor. 4K resolution is not supported when dual external
monitors are used.
Please note the following:
❖
Interlaced modes are not supported.
❖
The display modes listed above may not be supported
by your display, or your display may offer additional
modes not supported by the dynadock 4K docking
station. For information on display modes supported by
your display, be sure to check the documentation
supplied with your display. Select a mode that both the
dynadock 4K docking station and your display support.
❖
Placing a display into an unsupported mode for long
periods can damage it.
❖
If you are using Mirror mode to clone the primary
display's image on an external display, the dynadock 4K
docking station will attempt to use the same display
mode on the external display that you selected for the
primary display. In some cases, however, this may not be
the most appropriate mode for the mirrored desktop (for
example, if the aspect ratio of the displays is not the
same). In these cases, change the primary display mode
to match the optimum display mode for the external
display.
NOTE
Max Output Resolution & Refresh Rate
DisplayPort™
3840 x 2160 (30Hz)
Not connected
Not connected
2048 x 1152 (60Hz)
Not connected
For more information on supported modes, refer to the
documentation supplied with your display.
Adjusting Settings
*
HDMI™
Not connected
3840 x 2160 (30Hz)
Not connected
Not connected
2048 x 1152 (60Hz) 2048 x 1152 (60Hz)
31
DVI/VGA
Not connected
Not connected
2048 x 1152 (60Hz)
2048 x 1152 (60Hz)