Turning The Unit Off; Water-Trap Filter - WatchGas NEO Quick Start Manual

Turning the unit On
Press the Down Key for 3 seconds, until the buzzer
beeps and the red LED flashes. After a warm up and
self-test sequence, the unit enters normal reading
mode, showing real time gas concentrations.

Turning the unit Off

In normal reading mode, press and hold the Down
Key for a 5-second count down, until "Unit Off" is
displayed.
Charging
Always fully charge the battery before use. Plug the
charger to the bottom of NEO. The battery icon on the
LCD shows the charge status. During active charging,
the icon cycles from empty to full.
Charging/Comm Cable
The USB Charging/Communications cable allows
charging the unit on a personal computer. A local-
ly-purchased cable can work as well for charging, but
a WatchGas mPower cable must be used for proper
data transfer when communicating with mPower
Suite.

Water-trap Filter

Water-trap filters (P/N: M490-0004-010) are used to
protect the sensor from dust and aerosols in dirty en-
vironments. The filter should be twisted on to the gas
inlet before the instrument is used and replaced once
its surface is dirty.