READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure the electricity connections conform to the National Electrical Code and local regulations if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Any
modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
1
Ceiling
Screw Hole
Electric drill
Drill holes at desired location to
mount steel cables.
40070003 REV 2 - 09/17
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
INSTALLATION INSTRUCTIONS
CABLE MOUNTED
2
Steel
Cable
Connect steel cables to ceiling,
using appropriate hardware for
mounting surface.
4
Adjust to desired height, clean off
dust and debris.
1
INSTALLATION INSTRUCTIONS
3
Secure fixture to the end of the
steel cables, using appropriate
hardware.
800.533.3948 • www.barronltg.com
GRM