Makita DKP181 Instruction Manual page 10

5. Tighten two screws on the adjusting plate while
the adjusting plate being pressed.
6
5
2
1
2 4
1 3
► 1 . Blade gauge 2. Inside edge of blade gauge
3. Conventional planer blade 4. Blade edge (of con-
ventional planer blade) 5. Adjusting plate 6. Screw
7. Heel
6. Clean out all chips or foreign matter adhering to
the drum and the conventional planer blade.
7. Slip the heel of the adjusting plate into the drum
groove, then fit the drum plate on it.
1 2
► 1 . Drum groove 2. Heel 3. Drum plate 4. Installation
bolt
8. Tighten all the installation bolts evenly and alter-
nately with the box wrench.
9. Repeat the above procedures for the other con-
ventional planer blade.
7
3
4
5 6
7
3 4
10 ENGLISH
For tool with mini planer blades
1. To remove the mini planer blades from the tool,
loosen the installation bolts one turn with the box
wrench.
1
► 1 . Box wrench 2. Installation bolt
2. Slide and remove the mini planer blade from the
belt side of the tool.
Using the haft of the box wrench makes it easier
and safety.
1
► 1 . Haft of the box wrench 2. Mini planer blade
3. To install the mini planer blades, clean out all
chips or foreign matter adhering to the drum and
the mini planer blade.
4. Slide the mini planer blade from opposite side of
the belt of the tool.
5. Tighten all the installation bolts evenly and alter-
nately with the box wrench.
6. Repeat the above procedures for the other mini
planer blade.
To calibrate the relation between the set plate and the
adjusting plate, perform the following procedure.
1. Loosen the installation bolts one turn with the box
wrench, remove the mini planer blades from the
tool first, and then remove the installation bolts.
The drum plate and the set plate with adjusting
plate come off.
2
2