Adjusting The Height Of Cut - Toro Greensmaster 3300 Series Operator's Manual

8, 11, and 14-blade dpa reel mower traction units

Hide thumbs Also See for Greensmaster 3300 Series:

Operator's manual (16 pages)

Table Of Contents

Table of Contents

1. Sideplate mounting flange

2. Spacer

To adjust rear roller proceed as follows:

1. Raise the rear of the cutting unit and place a block

under the bedknife.

2. Remove the 2 nuts securing each roller bracket and

spacer to each sideplate mounting flange.

3. Lower the roller and screws from the sideplate

mounting flanges and spacers.

4. Place the spacers onto the screws above of below the

roller brackets, as required (Figure 6 or Figure 7).

5. Secure the roller bracket and spacers to the underside

of the mounting flanges with the nuts previously

removed.

6. Verify that the bedknife to reel contact is correct.

Tip the mower to expose the front and rear rollers

and the bedknife.

Note: The position of the rear roller to the

reel is controlled by the machining tolerances of

the assembled components and paralleling is not

required. A limited amount of adjustment is possible

by setting the cutting unit on a surface plate and

loosening the sideplate mounting bolts (Figure 8).

Adjust and tighten bolts when finished.

Figure 7

3. Roller bracket

1. Sideplate mounting bolts

Important: Whenever the cutting unit has to be

tipped to expose bedknife/reel, prop up rear of

cutting unit to make sure nuts on back end of

bedbar adjusting screws are not resting on work

surface (Figure 3).