Mazda 3 2020 Owner's Manual page 579

16.Insert the compressor plug into the
interior accessory socket and switch
the ignition to ACC.
1. Compressor
2. Compressor plug
CAUTION
Before pulling out the compressor
plug from the electrical socket,
make sure the compressor power
switch is off.
The compressor turns on and off
with the push-button switch.
17.Turn the compressor switch on and
inflate the tyre carefully to the
correct inflation pressure.
WARNING
Never operate the compressor
above 300 kPa (3.1 kgf/cm
bar, 43.5 psi):
Operating the compressor above
300 kPa (3.1 kgf/cm
psi) is dangerous. When the
inflation pressure rises above 300
kPa (3.1 kgf/cm
heated air will be exhausted from
the back of the compressor and you
could be burned.
NOTE
Check the tyre inflation pressure

label (driver's door frame) for the
correct tyre inflation pressure.
Do not use the compressor for

longer than 10 minutes because
using the compressor for long
periods could damage it.
If the tyre does not inflate, repair

of the tyre may not be possible. If
the tyre does not reach the
correct inflation pressure within a
10-minute period, it probably has
received more extensive damage.
When this happens, the
emergency flat tyre repair kit
cannot be used to repair the tyre.
Contact an expert repairer (we
recommend an Authorised
Mazda Repairer).
If the tyre has been over-inflated,

loosen the screw cap on the
compressor and bleed some of
the air out.
18.When the tyre has been inflated to
the proper inflation pressure, turn
the compressor switch off and
remove the compressor hose from
the tyre valve.
19.Install the tyre valve cap.
If Trouble Arises
Flat Tyre
2
, 3
2
, 3 bar, 43.5
2
, 3 bar, 43.5 psi),
7-35