Switching And Reboot Commands - Text Interface - Western Telematic M User Manual

9.2.2.

Switching and Reboot Commands - Text Interface

These commands can be used to switch or reboot the MPC's switched plugs, and can
also be used to set plugs to the user-defined Power-Up Default values. Plugs may be
specified by name or number.
• If a switching or reboot command is directed to a plug that is already being
switched or rebooted by a previous command, then the new command will
be placed in a queue until the plug is ready to receive additional commands.
• If an asterisk appears in the "Status" column for any given plug, this indicates
that the plug is currently busy, processing a previously issued command.
• Commands are not case sensitive. All commands are invoked by pressing
[Enter].
• When the Plug Control Screen is displayed by an account that permits
Administrator level command access, all switched outlets will be displayed.
• When you have accessed command mode using an account that permits
Administrator or SuperUser level commands, then switching and reboot
commands can be applied to all plugs.
• When you have accessed command mode via a User level account,
switching and reboot commands can only be applied to the plugs that are
specifically allowed for that account.
• If command confirmation is enabled, the MPC will display the Status Screen
after commands are successfully completed.
• When switching and reboot operations are initiated, Boot/Sequence Delay
times will be applied as described in Section 5.7.
• When used in On/Off/Reboot command lines, plug names and plug group
names are not case sensitive.
Notes:
9-5
Operation