Text Interface; Web Browser Interface; Granting Access To Plugs On Aux Units - Western Telematic M User Manual

Mpc series managed power controllers

Table of Contents

To grant access to plugs on AUX units, simply select the desired plugs from the

"Configure Plug Access" drop down menu and then click on the "Change Load

Shedding" button.

Text Interface

When Plug Access is defined via the Text Interface, the following procedure is used to

grant access to plugs on optional AUX units:

From the Load Shedding menu, type 4 and press [Enter] to display the Plug

Access menu. At the Plug Access menu, select plugs for your local MPC unit

as you normally would, and when finished, press [Enter] to return to the Load

Shedding menu.

To grant access to plugs on AUX units, type 4 and press [Enter] again to return to

the Plug Access menu, and then type > (greater than symbol) and press [Enter] to

scroll to the desired AUX MPC unit. When the desired AUX unit is displayed, select

plugs for the AUX unit as you normally would, and then press [Enter] to return to

the Load Shedding Menu.

Note: The first line of the Plug Access menu will indicate the name of the AUX

or Local MPC unit that is currently selected.

Repeat Step 2 above to grant access to plugs on additional AUX units.

When you have finished granting Plug Access rights for this alarm, define any other

desired parameters required, and then make certain to press [Esc] several times

until the "Saving Configuration" message is displayed and the unit returns to the

MPC command prompt.

7-16

Alarm Configuration

Table of Contents