Table of Contents
Advertisement
2.4 Connecting the sensors to the transmitter
lug the three sensor cables into the transmitter on the underside of the transmitter. Remembering
P
which cable is plugged into each socket.
(I.e. sensor 1 = Red etc.)
Press the release catch to remove the wall plate and use a double sided self-adhesive sticky pad
or screw (not supplied) to affix in a convenient position close to the cables being monitored.
Make sure the release catch in on the left hand side.
Fit 2 x AA Batteries into the transmitter making sure they are the right way round (see below)
Press and hold the square button on the transmitter while installing
the batteries to set it to 3 phase transmit mode
Smart 3pA Page 7
Once you have inserted the batteries you
should see the red light start to flash on
the Eco eye transmitter.
Clip the back onto the transmitter and
plug the sensors into the bottom of the
transmitter.
Advertisement
Table of Contents
