Normative References; General; Approved References; June 23, 2010 T13/2132-D Revision - Western Digital T13/2132-D User Manual

June 23, 2010

2 Normative references

2.1 General

The standards list in 2.2, 2.3, and 2.4 contain provisions that, through reference in the text, constitute provisions
of this standard. At the time of publication, the editions indicated were valid. All standards are subject to
revision, and parties to agreements based on this standard are encouraged to investigate the possibility of
applying the most recent editions of the standards listed in 2.2, 2.3, and 2.4.
Copies of these standards may be obtained from ANSI: Approved ANSI standards, approved and draft
international and regional standards (ISO, IEC, CEN/CENELEC, ITUT), and approved and draft foreign
standards (including BSI, JIS, and DIN). For further information, contact ANSI Customer Service Department at
212-642-4900 (phone), 212-302-1286 (fax), or via the World Wide Web at http://www.ansi.org.
Additional availability contact information is provided as needed.

2.2 Approved references

Copies of the following documents may be obtained from ANSI, an ISO member organization:
a) Approved ANSI standards;
b) approved international and regional standards (ISO and IEC); and
c) approved foreign standards (including JIS and DIN).
For further information, contact the ANSI Customer Service Department:
Phone +1 212-642-4900
Fax: +1 212-302-1286
Web: http://www.ansi.org
E-mail: ansionline@ansi.org
or the InterNational Committee for Information Technology Standards (INCITS):
Phone +1 202-626-5738
Web: http://www.incits.org
E-mail: incits@itic.org
Table 1 lists approved ANSI standards, approved international and regional standards (ISO, IEC,
CEN/CENELEC, ITUT). Additional information may be available at http://www.t10.org and http://www.t13h.org.
Volume and File Structure of CD-ROM For Information Interchange
Fibre Channel Framing and Signaling Interface - 2 (FC-FS-2)
(FC-LS)
AT Attachment 8 - ATA/ATAPI Command Set - 8 (ATA8-ACS)
Serial Attached SCSI - 1.1 (SAS-1.1)
Serial Bus Protocol - 2 (SBP-2)
Reduced Block Commands (RBC)
SCSI Primary Commands - 3 (SPC-3)
Multi-Media Commands - 5 (MMC-5)
BIOS Enhanced Disk Drive Services - 3 (EDD-3)
Extended Unique Identifier, 64-bit (EUI-64)
IEEE Standard for a High Performance Serial Bus
Working Draft Enhanced Disk Drive - 4 (EDD-4)
Table 1 — Approved ANSI References
Name
T13/2132-D Revision 3
Reference
ISO 9660-1988
INCITS 424-2007
INCITS 433-2006
INCITS 452-2009
INCITS 417-2006
INCITS 325-1998
INCITS 330-2003
INCITS 408-2005
INCITS 430-2007
INCITS 407-2005
ANSI/IEEE 394:1995
IEEE 1394-2008
3