Table of Contents
Advertisement
6-2 Back Mounting
Attach the 2 brackets using the on 4 holes on the back of the unit with the provided screws.
Bracket
6-3 Rubber Pad Installation
When placing the control unit horizontally, the Rubber Pad ( Provided ) is installed at the side
of the Selector Unit.
And when installing horizontally, remove the 4 screws on the Control Panel, and can use
NE261, moving the panel at the 90°Angle.
When moving the direction of setting control panel, need to get off the Power Switch and to
remove the Power Inlet.
CAUTION
Never install the control panel upward when setting the selector unit horizontally.
This may cause damage to control unit because of electric shock or fire.
When setting the control panel, get off the power switch and detach the fuse with
inlet from the Power Plug.
Rubber
Pad
Fig. 8
9
Bracket
Fig. 7
Control Panel
Screw
Fig. 9
6-4 Proper Clearance
When installing 2 or more control units in the machine cabinet make sure to check that each
single control unit has the proper clearance on all sides.
Vertical mounting
DIR
RESET
GEAR
CTRL
DIR
START
STOP
min.30mm
min.20mm
Fig. 10
7
POWER CORD CONNECTION
WARNING
Only use grounded power sources. Failure to properly ground the unit may result in
electric shock, injury, fire and/or damage to the system components.
( 1 ) Insert the female plug into the main power inlet box [ 15 ] on the front of the unit.
( 2 ) A screw hole is provided on the lower, right side of the control unit for attaching the
tension relief. Use the provided Nylon Tension Relief to attach the power cord to the side
of the control unit.
Nylon Tension Relief
Horizontal mounting
min.30mm
min.20mm
Fig. 11
[ 15 ]
Fig. 12
10
Advertisement
Table of Contents
