Table of Contents
Advertisement
4-2 Control Panel
[ 16 ]
[ 25 ]
[ 24 ]
[ 16 ] Error LED ( ERROR )
When a serious problem with the system is detected this LED blinks, the motor/spindle is shut
down and the Digital Speed Indicator in NE260 Control Panel displays the error code.
[ 17 ] Warning LED ( WARNING )
The operating and working conditions of the system are constantly monitored and the warning LED
blinks when a hazardous condition has been detected. When a hazardous condition is detected the
warning LED blinks and the Digital Speed Indicator in NE260 Control Panel alternates between the
warning code and the actual or preset speed, depending on whether or not the motor/spindle is
rotating.
[ 18 ] Rotating LED ( RUN )
When the motor is rotating this LED will flash.
[ 19 ] LINK LED ( LINK )
LINK LED blinks when NE261 is correctly connected to NE260.
[ 20 ] Motor LED
The LED corresponding to the selected motor lights.
[ 21 ] Motor Speed Adjustment Switch ( SPEED )
Set Motor Speed ( Up or Down )
[ 22 ] Rotation Direction Switch ( FWD./REV. )
Right hand rotation ( FWD. ) and left hand rotation ( REV. ) are as viewed with the cutting tool facing
the operator. With the cutting tool facing the operator right hand rotation ( FWD. ) will be clockwise
rotation.
[ 23 ] Motor Selection Switch ( MOTOR SEL )
Select Motor #1-Motor #4 If Motor #1 is selected, Motor1 LED [ 20 ] blinks.
[ 24 ] Motor Rotation Direction LED
LED lit Green indicates Right Hand Rotation ( FWD. )
LED lit Orange indicates Left Hand Rotation ( REV. )
[ 25 ] Digital Speed Indicator ( SPEED )
Preset Speed, Actual Speed are displayed to 2 digits.
7
[ 17 ]
[ 18 ]
[ 19 ]
[ 20 ]
[ 21 ]
[ 22 ]
[ 23 ]
Fig. 4
5
CHANGING FUSES
WARNING
• Before removing fuse make sure that the main power switch is in the off position
and the power cord is disconnected from the power supply.
• Make sure and use only the properly rated and type of fuse.
• Failure to use the proper type and rated fuse will result in fire, injury, electric
shock and/or product damage.
( 1 ) Push on the clips on the top and bottom of the fuse holder and remove the fuse holder and fuses.
( 2 ) Remove the bad fuse or fuses and replace with the proper type and rating of fuse as listed
below and determined by the input voltage being used.
Fuse : T1.6AL 250V
( 3 ) Replace the fuse holder containing the fuses into the fuse inlet box and make sure it snaps in place.
6
BRACKET INSTALLATION
CAUTION
• If there is a threat to fall the control unit from the desk, be sure to place it with the
provided brackets for safety.
• Never install the unit in such a manner as to block the air vents on the side of the
control unit. This manner of installation will cause heat buildup and damage to the
internal components of the control unit.
( 1 ) Two mounting brackets are provided with the system.
( 2 ) The brackets can be installed on the bottom or on the back of the control unit.
( 3 ) After installing the brackets you can use the screw cutouts to mount the control unit.
6-1 Bottom Mounting
Attach the 2 brackets using the 4 holes the bottom of the unit with the provided screws.
Bracket
Cap
Fig. 5
Bracket
Fig. 6
8
Advertisement
Table of Contents
