Westell Technologies Westell LiteLine 6000 User Manual page 50

User Guide
VPI
VCI
PCR
QoS
Protocol
Status
IP Address
Gateway
DNS Primary
DNS Secondary
MRU Negotiation
LCP Echo Disable
LCP Echo Failures
LCP Echo Retry Duration
LCP Echo Retry Duration
Tunneling
NOTE: The values for IP Address, Gateway, DNS Primary, and DNS Secondary are all "Override of the value
obtained from the PPP connection," They default to "0.0.0.0," in which case the override is ignored. Westell
recommends that you do not change the values unless your Internet Service Provider instructs you to change them.
030-300411 Rev. A
VC 1 Configuration
This setting allows you to change your VPI (Virtual Path Indicator) value for a
particular VC, which is defined by your Service Provider.
This setting allows you to change your VCI (Virtual Channel Indicator) value for a
particular VC, which is defined by your Service Provider.
Factory Default = 100%
Peak Cell Rate (PCR)-The maximum rate at which cells can be transmitted across a
virtual circuit, specified in cells per second and defined by the interval between the
transmission of the last bit of one cell and the first bit of the next.
This value is a percentage of the current data rate.
100 allows this VC to use 100% of the available bandwidth.
80 allows this VC to use 80% of the available bandwidth.
Quality of Service, which is determined by your Service Provider.
CBR = Constant Bit Rate
UBR = Unspecified Bit Rate
VBR = Variable Bit Rate
The Protocol for each VC, which is specified by your Service Provider.
PPPoA = Point to Point Protocol over ATM (Asynchronous Transfer Mode)
PPPoE = Point to Point Protocol over Ethernet
Bridge = Bridge Protocol
Classical IPoA = Internet Protocol over ATM (Asynchronous Transfer Mode). This
is an ATM encapsulation of the IP protocol.
The protocol status.
VC x PPPoE Settings
Displays the IP network address that your modem is on.
Displays the router IP Gateway address
Provided by your Service Provider
Provided by your Service Provider
Factory Default = DISABLED
If ENABLED, the Maximum Received Unit (MRU) would enforce MRU
negotiations. (NOTE: enable this option only at your Internet Service Provider's
request.)
Factory Default = Enable
If checked, this option will disable the modem LCP Echo transmissions.
Indicates number of continuous LCP echo non-responses received before the PPP
session is terminated.
Indicates the interval between LCP Echo transmissions with responses.
Indicates the interval between LCP. Echo after no response.
Factory Default = ENABLE
If ENABLED, this option allows PPP traffic to be bridged to the WAN. This feature
allows you to use a PPPoE shim on the host computer to connect to the Internet
Service Provider, by bypassing the Router's capability to do this.
Westell (Models 6000, 6100, 6110)
50 July 2004