Westell Technologies Westell LiteLine 6000 User Manual page 13

User Guide
NOTE: The modem features shown in Figure 2 apply to the Model 6100 and Model 6110 products. The Model 6000
product has only Ethernet. The power switch is optional for all products discussed in this document.
5.4.3 Installation via 10/100 Base-T Ethernet and USB (Simultaneous
Installation for Models 6100 and 6110)
Models 6100 and 6110 support simultaneous use of 10/100 Base-T Ethernet and USB ports. The following
instructions explain how to install your Modem for simultaneous use of Ethernet and USB ports.
Refer to Figure 3.
1. Connect the power supply cord to the power connector marked
other end of the power supply into an AC wall socket.
2. Connect the DSL phone cable from connector marked
telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must use the
phone cord that was provided with the Modem kit.
3. Connect the yellow Ethernet cable from the yellow Ethernet jack marked
Modem to the Ethernet port on your computer.
030-300411 Rev. A
Figure 2. Connection via USB
12V
on the rear panel of the Modem to the DSL-equipped
13
Westell (Models 6000, 6100, 6110)
~
on the rear panel of the Modem. Plug the
on the rear panel of the
July 2004