Changing Fuses; Bracket Installation - Nakanishi E3200 Series Operation Manual

[ 19 ] Error LED (ERROR)
When a serious problem with the system is detected this LED blinks, the motor/spindle is
shut down and the Digital Speed Indicator [ 11 ] displays the error code.
[ 20 ] Warning LED (WARNING)
The operating and working conditions of the system are constantly monitored and the
warning LED blinks when a hazardous condition has been detected. When a hazardous
condition is detected the warning LED blinks and the Digital Speed Indicator [ 11 ] alternates
between the warning code and the actual or preset speed, depending on whether or not the
motor/spindle is rotating.
[ 21 ] Rotating LED (RUN)
When the motor is rotating this LED will flash.

CHANGING FUSES

7
WARNING
Before removing fuse make sure that the main power switch is in the off position
•
and the power cord is disconnected from the power supply.
Make sure and use only the properly rated and type of fuse.
•
Failure to use the proper type and rated fuse will result in fire, injury, electric
•
shock and/or product damage.
(1) Push on the clips on the top and bottom of the fuse holder and remove the fuse holder and
fuses.
(2) Remove the bad fuse or fuses and replace with the proper type and rating of fuse as listed
below and determined by the input voltage being used.
Fuse : T6.3AL (250V)
(3) Replace the fuse holder containing the fuses into the fuse inlet box and make sure it
snaps in place.
13
Cap
Fig. 13

BRACKET INSTALLATION

8
CAUTION
• If there is a threat to fall the control unit from the desk, be sure to place it with the
provided brackets for safety.
• Never install the unit in such a manner as to block the air vents on the side of the
control unit. This manner of installation will cause heat buildup and damage to the
internal components of the control unit.
(1) Two mounting brackets are provided with the system.
(2) The brackets can be installed on the bottom or on the back of the control unit.
(3) After installing the brackets you can use the screw cutouts to mount the control unit.
8-1 Bottom Mounting
Attach the 2 brackets using the 4 hole on the bottom of the unit using the provided screws.
Bracket
8-2 Back Mounting
Attach the 2 brackets using the 4 holes on the back of the unit using the provided screws.
Bracket
Bracket
Fig. 14
Bracket
Fig. 15 14