Advertisement
3. SAFETY INSTRUCTIONS
3.1
General Safety
WARNING! Ensure Health & Safety, local authority, and general
workshop practice regulations are adhered to when using this
tool.
WARNING! Familiarise yourself with the specific applications
and limitations of the kit, as well as any potential hazards.
Ensure that the kit is correct for the task.
Wear the appropriate personal protective equipment for the
task. A full range is available from your Sealey dealer.
DO NOT use a workshop press to fit GEN2 wheel bearings.
DO NOT fit a wheel bearing with a damaged retaining ring.
DO NOT use the kit for any purpose other than that for which it
is designed.
DO NOT use air tools with this kit to remove/install bearings.
Always keep force screw well lubricated.
Ensure that the vehicle is properly supported with axle stands
before working under the vehicle.
Ensure there is adequate lighting prior to using the kit. A range
of inspection lamps are available from your Sealey dealer.
Keep children and unauthorised persons away from the working
area.
DO NOT use the kit if any parts are damaged or missing, as this
may cause failure and/or personal injury.
DO NOT use the kit when you are tired, or under the influence of
alcohol, drugs or intoxicating medication.
After use, store in a safe, dry childproof area.
s IMPORTANT: Always refer to the vehicle manufacturer's service
instructions, or a proprietary manual, to establish the current
procedure and data.
WARNING: The warnings, cautions and instructions in this
manual cannot cover all possible conditions and situations
that may occur. It must be understood that common sense
and caution are factors which cannot be built into this
product, but must be applied by the operator.
4. INTRODUCTION
A selection of kits designed for the second generation of wheel bearing found on modern vehicles. These bearings are
lightweight with an integral mounting flange. They are also pre-loaded with a retaining ring that secures the bearing into
the housing. Each kit is individually designed to suit the relevant vehicle manufacturer. These kits can be used in-situ
when replacing the front wheel bearing. Knowledge of the outer bearing diameter is required before selecting the
appropriate kit, as some vehicles are fitted with more than one size of bearing.
5. OPERATION
5.1
Bearing Removal (fig.2 & fig.3)
5.1.1 Prepare the vehicle for the wheel bearing to be
removed.
Note: When GEN2 wheel bearings are removed, the
retaining ring will sustain damage. DO NOT re-fit a
bearing once it has been removed.
5.1.2 Fit the black hub clamp (8) behind the hub flange
with the recessed side facing the hub carrier. Secure
the hub clamp (8) with the hub clamp screws (7).
5.1.3 Fit the hub guide pins (6) into the thrust plate (2) so
that the hub guide pins (6) align with the holes in
the hub flange. Place the hub guide pins (6) though
the holes in the hub flange so that they sit against
the hub clamp (8) (fig.3).
5.1.4 Lubricate the force screw (1).
5.1.5 Fit the force screw (1) through the thrust plate (2) and
through the bearing and hub carrier.
5.1.6 Place the black bearing plate (4) over the force screw
(1) so that it sits on the outer race of the bearing.
© Jack Sealey Limited 2012
fig.2
Original Language Version
VS7027, VS7028, VS7029, VS7030
Issue No.1 - 02/08/12
Advertisement
