Page 2
Any attempt to directly control or at all connect into the S-link control system without the designated and approved interface, will render all warranties and responsibilities for the complete line of Side-Power products connected void and null. Installation guide S-link control panel type 8700 Page 2...
Page 3
Twist the locking ring on the connector clockwise to secure connector. Put the panel (1) in place and screw in and tighten the four screws (3) Press gently each of the four corner clips (4) into their corner slot Installation guide S-link control panel type 8700 Page 3...
Page 4
Remote control thruster ( opt.) (opt.) optional Setup with manual main switch Retract panel +12V Battery Drawn: Sleipner Motor AS Power supply P.O. Box 519 black Wiring Retract thruster cable N-1612 Fredrikstad W / manual main switch yellow Draw no: Norway...
Page 5
S-link Setup Procedure: To control a dual thruster setup on one S-link bus, the panels must be set up to control one thruster each. As factory default, the panel is setup to control the bow thruster. The panel controlling the stern thruster must be set up fol- lowing the procedure described: Disconnect all S-link equipment concerning the bow thruster (Panel, AMS, Thruster Control Box, Interface etc.) from the S-link bus, and keep...
Page 7
We Sleipner Motor AS declare that these control panels complies with health and safety requirements according to the Directive 89/336/EEC of 23 May 1989 amended by 92/31/EEC and 93/68/EEC.
Need help?
Do you have a question about the 8700 and is the answer not in the manual?
Questions and answers