Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for anko RFC-1708
Summary of Contents for anko RFC-1708
- Page 1 Hair Clipper Instruction Manual Model no.: RFC-1708...
- Page 2 SAFETY GUIDE - PLEASE READ CAREFULLY BEFORE USING THIS APPLIANCE Please follow all the precautions listed below for safety and to reduce the risk of injury or electric shock. WARNING: READ ALL INSTRUCTIONS; FAILURE TO FOLLOW ALL INSTRUCTIONS LISTED BELOW MAY RESULT IN ELECTRIC SHOCK, OR SERIOUS PERSONAL INJURY.
- Page 3 use. 24. Do not stretch, twist and curl the cable around the appliance. CAUTION: Electric Shock Hazard. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water.
- Page 4 INTRODUCTION This appliance is designed for household use only. The appliance can be used at 100-240V voltage. Before you put the charger into the outlet, make sure the voltage is compatible with the required voltage on the product. PARTS Blade Set 9mm Comb attachment Taper lever 12mm Comb attachment...
-
Page 5: Battery Care
CHARGING THE HAIR CLIPPER Charge the appliance for 12 hours before first use. Ensure the product is OFF before charging. Connect the charger to the product and then to the mains socket. The charging indicator will illuminate RED and remain illuminated. Indicator will change to GREEN when the unit is fully charged. - Page 6 WARNING: Switch off the clipper before replacing or changing the attachments NOTES: The hair to be dressed must be dry. NOTES: The cutting length may deviate depending on the cutting angle. Please start with a comb attachment with a longer cutting length and then, in the course of cutting process, use shorter cutting lengths step by step .
-
Page 7: Blade Alignment
BLADE ALIGNMENT It is possible the blades may go out of alignment after long use. Correct blade alignment is essential for effective cutting. To align the blades, please follow below steps: 1. The end of the top blade should be closer to the body of the hair clipper than the moving blade. -
Page 8: Battery Disposal
Used batteries should be taken to a recycling station and not disposed of with household waste. IMPORTANT: Always fully discharge the batteries before removal and ensure the charger is unplugged. TECHNICAL SPECIFICATIONS Model no. RFC-1708 Working time Approximately 2hr Charging time 2.5hr Battery Charger... - Page 9 12 Month Warranty Thank you for your purchase from Kmart. Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided.
Need help?
Do you have a question about the RFC-1708 and is the answer not in the manual?
Questions and answers