Checking Installation Work - Panasonic GHP Test Run Manual

Ⅰ. Checking before operation

1. Checking installation work

(1) Installation work check
 If there is a problem with the installation work, make a request through the sales representative that the problem be
remedied and measures be taken.
 Write the necessary information in the "GHP Test Run Checklist (2WAY Multi/W Multi). (Refer to the appendix.)
(2) Outdoor unit check
 Applicable Gas Type
Group
Gas composition
Standard gas
Calorific value
3
(MJ/m N)
45.0 kW Type
56.0 kW Type
Model
Name
71.0 kW Type
85.0 kW Type
Applicability : Standard setting when shipped from the factory
: Necessary to change the gas type setting on site
 External appearance check
● Confirm visually that there is no external damage to the product caused during transport or subsequently.
● In particular, the heat exchanger fan is easily scratched, and some customers have pointed out scratches when
outdoor units were handed over. Be careful.
 Accessory check
Required accessories
Instruction manual
Warranty
Labels
 After operation is finished, check that items such as the instruction manual and warranty have not been lost
when handing over the outdoor unit to the customer.
 A list of all the accessories is included in "Procedures and Technical Points for System Installation," but the ac-
cessories required after installation are those shown in the table above.
* In addition to the table above, the following are supplied with the outdoor unit at the time of shipment. Refer to
them together with this test run manual.
● Procedures and Technical Points for System Installation
● Procedures and Technical Points for Electrical Wiring Work
● Procedures and Technical Points for Test Run
P
C H 100%
3 8
G31
95.65
Storage location
These items are all stored in a plastic bag
which is attached to the inside of the face
panel with the display window for the
operation time.
H
CH 100% CH 86% N
4 4
G20
37.78
Explain how to use the manual when you hand it
over to the customer.
Fill in the relevant items when you hand over the
warranty to the customer.
● Remote power switch label
● Refrigerant tube length and refrigerant charge
amount
● Label for a seal
● Warning label
Ⅰ－1
L E
14% CH 100%
2 4
G25 G20
32.49 37.78
Remarks