oventrop OV-DMC 3 Operating Instructions Manual page 15

"OV-DMC 3" Software
Computer 1. Enter the required flow rate
method
2. Set the valve to be
regulated to any presetting
3. Select "Start measurement"
4. Set the valve to be
regulated to any presetting
again
5. The presetting for the
required flow rate is
determined by the software
6. Set the determined value at
the valve to be regulated
7. Select "Start measurement"
8. When the measured flow
rate corresponds to the
determined value, transfer
this value into the regulation
record
106927881-V02.02.2020
6.3 Evaluation of the measuring
result
6.3.1 Display of the measuring result
If "Measure" has been selected, the result of
the measurement can be displayed in table
form on your display device.
f Select the button "Call up table with
measuring results"
12).
6.3.2 Display and printout of the
measuring result
f Select the button "Save measuring results"
(see 5.2.1 on page 12).
f A window with different selection options
opens:
Save
Save and A window in which you may
start new save the measuring result as
measurement
new design opens
The naming is free
Save and go The values of the completed
to project measurement are saved
details
under the current project
The naming is free
Cancel Return to menu "Measure"
Commissioning
(see 5.2.1 on page
15
EN