Connection Status Confirmation - Toa TS-D1000 Series Instruction Manual

9. CONNECTION STATUS CONFIRMATION

After the PC is connected to the TS-D1000-MU (see
browser screen, click on "Connection Test." The Connection Test screen is displayed.
1
4 5
(1) RESET ID button
Click to reset the Conference unit ID number.
For reset instructions, please refer to
(2) STOP TEST button
Click to terminate the connection confirmation.
(3) All-unit Connection Test button
Click to check that all Conference units in the system are correctly connected. All Conference unit
microphone indicators will flash when clicked, and extinguish when clicked again.
(4) ID Number
This is the ID number that has been assigned to each Conference unit, and cannot be changed.
(5) Unit Type
The indication "Chairman unit" or "Delegate unit" is displayed as the Conference unit's device name. This
name also cannot be changed.
(6) Connection Test button
Click when wishing to check individual Conference units to see if a specific unit is correctly connected.
Clicking this button causes the microphone indicator corresponding to the displayed ID number to flash.
Clicking on the same button again extinguishes the indicator.
Note
Multiple arbitrary Conference units cannot be checked simultaneously.
p. 4), from the menu bar located at the top of the
the next page.
2
3
6
13