Advertisement
Table of Contents
FCC Part 15
This device complies with FCC Rules Part 15 operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
Changes or modifications to this device, not expressly approved by XXXX. could
void the user's authority to operate the equipment.
Contains FCC ID: W72-N1LD
Contains IC ID: 8253A-N1LD
FCC RF Exposure Requirements:
This product complies with the FCC RF exposure limit set forth for an
uncontrolled environment and is safe for intended operation as described in this
manual. This device is only authorized for use in a mobile application, at least 20
cm of separation distance between the radiating antenna and the user's body
must be maintained at all times. Further RF exposure reduction can be achieved
if the product can be kept as far as possible from the user's body or set the device
to a lower output power if such a function is available. Separate approval is
required for all other operating configurations, including portable configurations
with respect to 47 CFR Part 2.1093 and different antenna configurations.
Industry Canada Notifications
This device complies with Industry Canada's license-exempt RSSs. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Questions or feedback?
support.neur.io
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement
Installing Neurio requires working with voltages that are hazardous
to human health, and thus should only be done by a qualified
professional. Installations should be performed in accordance
with the applicable electrical code for the region in which Neurio is
being installed. Whenever possible, power should be disconnected
upstream from the installation location before attempting installation
of Neurio. If power cannot be disconnected, high voltages may still
be present, and caution must be taken to avoid injury. If Neurio
is not used as instructed, its protection mechanisms may be
impaired. Rules: 1. Installations should be performed by a qualified
professional. 2. Do not use Neurio with voltages that exceed 240V. 3.
Only install Neurio in approved breaker panels or enclosures. 4. Neurio
must not be exposed to moisture, direct sunlight, extremely low or high
temperatures, and conductive pollution. Consult the User Manual for
Neurio's acceptable operating environment. 5. Neurio must be installed
in a location that limits access to only qualified personnel.
Hide quick links:
Advertisement
Table of Contents
