Bissell CROSSWAVE CORDLESS 2551 Series Quick Start Manual page 2

QUICK START GUIDE
Getting the Best Clean from Your CrossWave® Cordless
everyday
For Cleaning:
HARD FLOORS & RUGS
Choose the setting that matches the floor type you will
be cleaning. Prime the system by holding the solution
spray trigger for 10 seconds. Then, hold the trigger on
both the forward and backward pass for great cleaning
results.
10 Seconds
HARD FLOOR
RUG
Tips & Tricks
» On hard floors, there is no need to
vacuum before using CrossWave
Cordless. This machine vacuums and
washes at the same time.
» Be sure to charge your machine fully
before using for the first time.
Dirty
Machine?
EASY CLEANUP
For the best results, flush the unit by using the 3-in-1 Docking Station and holding down the Clean Out Cycle button on
the carry handle. Then, rinse the Dirty Water Tank, Strainer, Brush Roll, and Brush Chamber. Allow your machine and
components to dry completely, then reassemble, making sure the machine's brush window is secure for next use.
1
Clean Up
15s
» To dry floors faster, release the
trigger and run the machine over the
floor without dispensing solution.
» When cleaning area rugs, remove
any excessive mud from your area
rug prior to using your CrossWave
Cordless.
2
Dry
» When cleaning excessively dirty
or muddy hard floors, or if the
Brush Roll looks dirty, use the 3-in-1
Docking Station to rinse the Brush
Roll before cleaning your area rugs.
For further instructions
reference the User Guide or visit
www.BISSELL.com
3
Reassemble
» For overly challenging and stuck-on
messes on hard floors, activate the
RUG mode and hold your CrossWave
Cordless over the mess. Using short
passes while holding the trigger
allows the multi-surface brush to go
to work.