Assembly - Weslo WLTL48410 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove the packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
cutters and needlenose pliers
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Washer (39)–2
Handrail Nut (93)–2
1. With the help of a second person, carefully raise the
Uprights (11) until the treadmill is in the position shown.
Cut the tie from the right Upright (11).
2. Back out the Extension Leg Screw (53). Insert one of
the Extension Legs (34) into the treadmill as shown.
(Note: It may be helpful to tip the Uprights [11] in the di-
rection shown by the arrow as you insert the Extension
Leg.) Make sure that the Base Pad (40) is on the indi-
cated side of the Extension Leg. Attach the Extension
Leg with an Extension Leg Screw. Be sure to push on
the head of the Extension Leg Screw while tighten-
ing it.
Attach the other Extension Leg (34) in the same way.
.
Handrail Washer (92)–2
, adjustable wrench
Handrail Bolt (91)–2
Screw (80)–6
Short Handrail Bolt (89)–2
1
2
, wire
Tie
11
11
53
34
40