Advertisement
Assembly
Post
5
• While sliding the ends of the handlebar into the indents
on each side of the zebra's head, fit the post into the slot
in the top of the zebra's head.
6
• Insert four screws into the handlebar and tighten.
Handlebar
• For longer life use alkaline batteries.
• Locate the battery compartment on the back of
the handlebar.
• Loosen the screws in the battery compartment door and
remove the door.
• Insert three AAA (LR03) alkaline batteries.
• Replace the battery compartment door and tighten
the screws.
• If this toy begins to operate erratically, you may need to
reset the electronics. Slide the power/volume switch off and
then back on.
• When lights or sounds from this toy become faint or stop,
it's time for an adult to change the batteries.
4
Battery Installation
1,5V x 3
AAA (LR03)
• Protect the environment by not disposing of this
product with household waste (2012/19/EU).
Check your local authority for recycling advice
and facilities.
Advertisement
