Advertisement
Install the Plumbing
1. Install the drain in accordance with the manufacturer s
instructions.
NOTE:
The distance from center of vanity drain hole to the
wall is 78mm/81mm(see roughing-in), and please choose
suitable drainage pipe.
Caution!
Make sure a watertight seal exists on all
basin drain connections.
Caution!
Provide access to the plumbing connections
for future plumbing maintenance.
2. Connect the hot and cold water supplies.
3. Open the hot and cold water valves, and check the supply
connections for leaks.
4. Run water into the basin, and check the drain connections
for leaks.
Take out Deck and place it at the designated place after
installation is finished.
IMPORTANT CONSUMER INFORMATION
IMPORTANT CONSUMER INFORMATION
CARE AND CLEANING
Caution! Risk of product damage.
Many cleaners contain abrasive and chemical substances,
and should not be used for cleaning stainless steel, enamel,
plated or plastic fittings.
These finishes should be cleaned using a mild washing up
detergent or soap solution, rinsed and then wiped dry with a
soft clean cloth.
To keep your lavatory looking new, make sure you rinse it out
thoroughly after each use.
product, as they will scratch and ruin the surface. Stubborn
stains, paint, or tar can be removed with turpentine or paint
thinner.
SERVICE PARTS
SERVICE PARTS
1365697-T01-A
DO NOT USE ABRASIVES
1034692
Assy. Pack
,
1.
)
2.
3.
4.
Fig.#5
5
on this
1337784
Deck
-4-
78mm/81mm(
880089-CP
Operationg Rod
(For K-22780T-1)
(
K-22780T-1)
Advertisement
