Makita PV7000C Technical Information page 5

R
epair
<3> Disassembling armature
(1) Take off accessories (rubber pad, abrasive disc. etc.) from the machine, and remove carbon brush.
(2) Disassemble gear housing from motor housing by unscrewing 4 pcs. of tapping screws 5x40. See Fig.9.
In case of Mod.PV7001 and PV7001C, disconnect the grounding lead wire from gear housing cover
by unscrewing pan head screw. See Fig. 9A.
Gear housing
Carbon brush
Brush holder cap
(3) Disassemble gear housing cover from motor housing and take out armature from motor housing.
See Fig.10.
Gear housing cover
C
aution
The caution is carved on the side grip for Model PV7000C as illustrated in Fig. 11.
For efficiently prevention of static electricity accumulation, the above side grip is conductive in comparing with
other side grips. Therefore, you would not be protected from electric shock, when you would hit the live wire
with the other machine equipped with this side grip, for example, drill, hammer drill or angle grinder, etc.
Do not install this side grip on other than PV7000C.
Tapping screw 5x40.
Fig.9
Armature
Baffle plate
Motor housing
Fig.10
FOR POLISHERS ONLY
Fig.11
Gear housing cover
Motor housing
Grounding lead wire
P 5 / 15
Pan head screw
Fig. 9A