Weslo WLEL71807.0 User Manual page 7

5. Tip: Be careful not to pinch the Upper Wire (44)
and the Lower Wire Harness (53) during this step.
While another person holds the Upright (2) near the
Frame (1), connect the Upper Wire (44) to the Lower
Wire Harness (53). Push the excess wire downward
into the Frame. Next, slide the Upright onto the Frame.
Attach the Upright with two M10 x 68mm Button Bolts
(48), two M10 Split Washers (59), and two M10 Nylon
Locknuts (33). Do not tighten the Button Bolts yet.
6. Identify the Left Handlebar (6), which is marked with a
"Left" sticker. Insert the Left Handlebar into one of the
Handlebar Arms (5); make sure that the Handlebar
Arm is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar with two M6
x 38mm Button Bolts (50) and two M6 Nylon Locknuts
(27). Make sure that the Nylon Locknuts are inside
the hexagonal holes. Do not fully tighten the Button
Bolts yet.
Apply a small amount of the included grease to the left
axle on the Upright (2).
Make sure that there are two Small Handlebar
Bushings (49) in the Left Handlebar (6). Slide a
Handlebar Spacer (47) and the Left Handlebar onto the
left axle on the Upright (2) as shown. Make sure that the
Handlebar Spacer is turned so the curved side is fac-
ing the Upright. Then, tap an Axle Cap (14) onto the
axle.
Repeat this step to assemble the Right Handlebar
(8) and the other Handlebar Arm (5).
5
2
33
6
6
49
14
50
5
7
59
48
Avoid pinching
44
or damaging the
wires during
53
this step
1
8
2
Grease
5
47
27
Hexagonal
Holes