Advertisement
Instructions for Use
)
Connect cord set provided or other
cable with standard modular phone plug
to jack on the side of Talk-N-Trace™.
Connect headset to 2.5mm phone jack
at top.
2)
Connect Talk-N-Trace™ to wire pair to
be used for connecting the two Talk-N-
Trace™ sets. Polarity does not matter.
If ringer sounds when Talk-N-Trace™ is
connected, the wire pair is energized.
Disconnect leads and use a different
pair or remove power from current pair
before continuing.
)
Connect other Talk-N-Trace™ unit(s)
to other end(s) of the line. Up to four 4
Talk-N-Trace™ units may be connected
on one circuit.
4)
Press "ON" button to turn Talk-N-
Trace™ on. There should be a small
background hiss in the ear-piece when
the unit is on. Adjust volume switch as
required. Press "ON" a second time to
cause ringing on other units. The ring
tone continues as long as the button is
held down.
5)
Connect test leads to banana jack at
4
Advertisement
