Meter Jack - Kenwood TS-990S In-Depth Manual

METER Jack

Connecting an analog meter to the METER jack enables it to indicate the signal level of the transmitting and receiving
signals using the main band and sub band. Output signal type can be configured for the main band and the sub band
respectively. The same signal can also be sent from the ACC 2 connector.
The METER jack output rating is as described below.
• Voltage: 0 to 5 V (no load)
• Impedance: 4.7 kΩ
Main Band Meter
(+)
Note:
◆ To connect a commercially available meter to the METER jack, add resistors and/or variable resistors as needed.
Fig. 135 METER Jack
(-)
To Meter
Fig. 136 Example of a Meter Circuit
Sub Band Meter
(+) (-)
See a Note below
See a Note below
TERMINAL 08
Φ3.5 mm plug
87