Advertisement
Mounting Instructions
1).
Build cabinet adhering to the inside dimensions given in Dia. A. Before cutting front panel it is recommended that cabinet be built and
mounted securely to the wall with the bed mechanism installed before sizing front panel. This assures that the mechanism is working
properly first and only then can the front panel be properly fitted inside the opening.
2).
Mark drilling positions on both inside panels using the included template. Dia. 1
3).
Drill 5/16" (8.5 mm) holes all the way through side panels, Dia. 2 and counter sink outside edges.
4).
Fasten the two mounting brackets with the bolts provided as in Dia. 3
5).
Slide bed frame onto mounting brackets and hook over the studs. Fold bed frame up to the vertical position aligning holes.
Insert remaining 5 bolts and tighten securely Dia. 4.
Caution: Before testing be absolutely sure cabinet is securely anchored to wall. Keep fingers clear from folding feet and mechanism while
folding. If front panel or mattress are too heavy, bed may fall too quickly.
Note:
At this point bed frame will spring to the wall very quickly and conversely will be difficult to pull down.
Only after the additional weight of front panel and mattress have been added will ease of operation be achieved.
6).
Mount front panel to frame. Front panel should be cut to allow for a minimum of 1/8" (3 mm) gap around all edges of cabinet.
Screw M4 set screws into top of Z-Brackets which allow for adjustment and alignment of front panel. Attach Z-Brackets to front
panel so they will line up and hook over top and bottom rails of bed frame. Final attachment is with wood screws through holes
in frame. Be sure front panel is securely fastened before operation of frame.
7).
To adjust the position of the front panel in the closed position, adjust the nut at the end of the sleeve which holds the gas piston
using a 17 mm wrench. Also needed is an additional wood strip (stop) to be added under the top panel to ensure that the bed
closes absolutely vertical.
8).
Attach chrome-plated mattress stop through the two holes in the front of the frame using capped nuts and washers provided.
This will keep the mattress from sliding down as the bed is folded vertical.
9).
Place mattress on frame and secure with bedding straps. Loop curved clasp on one side around the frame and back
through itself. Repeat on the opposite side with the flat clasp. Stretch both over the mattress and hook together. Tighten
over mattress via adjustment on strap.
Diagram 1
Diagram 3
Diagram 2
Diagram 4
Advertisement
