Pager Charging; Pairing Instructions - Alert-it Companion Mini Handbook

12

Pager Charging

The pager's battery should last approximately 3 days depending on how many alarm cycles it goes through during
this period.
When the pager's battery starts to get low the green Pager LED (Figure 2) will start to flash every second
indicating the pager should be plugged into the provided charger. When the battery is very low, the pager will
sound every minute.
The Pager LED will blip off every 8 seconds during boost charge and will be solid green when the battery is
approaching full charge.
Charge for at least 12 hours.

Pairing Instructions

The monitor will usually be paired to the pager before it is shipped to you. If you should ever need to pair the items
again, please follow the instructions below.
Pairing the Monitor to the Pager
Ensure the monitor is turned on. Pairing is only possible within 30 seconds of powering up the pager. To pair the
Monitor to the Pager place the monitor close to the pager and press and hold the "Pair" button on the pager.
Stimulate any radio transmission from the monitor (to do this press the reset button, trigger an alarm or just wait for
the 8 second Safelink signal).
®
If successful you will hear a beep and see the red "Monitor" LED blip when pairing is successful, you can then
release the "Pair" button. A lower burp with no red light indicates the monitor is too far away to pair. This protects
against falsely pairing with another, distant, monitor.
To clear all paired monitors from the pager memory, press and hold both the "ON/OFF" button and the
"Mute/ Pair" button together within the first 30 seconds after power-up, until the ensuing tone sequence has
finished sounding and the green "Pager" LED illuminates, then release both buttons.