Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Pro-Lift G4U-WM
Summary of Contents for Pro-Lift G4U-WM
- Page 2 Thank you for purchasing a Pro‐LIFT G4U‐WM. The Pro‐LIFT product line is designed to enhance your interactive whiteboards and projectors. Please follow all assembly instructions correctly to provide optimal use. Only a qualified contractor should install the Pro‐LIFT G4U‐WM. If you do not understand any of the assembly instructions, please contact your local re‐seller or visit www.proliftstand.com. IMPROPER INSTALLATION CAN CAUSE DAMAGE TO YOUR Pro‐LIFT AND LEAD TO SERIOUS PHYSICAL INJURY. JORO Manufacturing cannot take any responsibility for damage or injury resulting from improper installation. The supplied mounting hardware is for use on the Pro‐LIFT stands only. If you encounter any problems or insufficient hardware during installation, please contact your local re‐seller. ...
- Page 3 Pro-LIFT G4U WM Assembly Sheet Wall Mount Angle Top Projector Mount Bottom Projector Mount Board Mount Wall Mount Leg Control Panel Control Panel Arm Pencil Tray Mount Wall Mount Angle OPEN BOX and IDENTIFY ALL PARTS!! C – 6pcs F – 6pcs A – 12pcs H - 5/32 Hex Key K – 4pcs (M6x8mm lg.) (Nylon Washer) ...
- Page 4 Pro-LIFT G4U WM Assembly Sheet Wall Mount Angle Wall Mount Leg A Pencil Tray Mount Plate F Mounting Bar Pencil Tray Mount Plates B F G G B STEP 1 STEP 2 Install Pencil Tray Mount Plate Install Pro-LIFT Wall Mount (Requires 4 bolts, insulators and washers) ...
- Page 5 Pro-LIFT G4U WM Assembly Sheet K K D Wall Mount Leg Wall Mount STEP 5 STEP 6 Install Projector Mount End Caps Install SMART Board Hanger (Requires 4 End Caps) (As per manufacturer’s specification) Align the end cap with the end of the projector mount. For 1 Hanger/Requires 3 bolts ‐ For 2 Hangers/Requires 6 bolts Insert end cap into end of projector mount and gently tap with rubber mallet. Use holes which correspond to manufacturers recommended projector to image distance. Note there are drilled/tapped holes on the wall mount leg if lowering the board is required. BE SURE TO NOT OVER TIGHTEN IF LOWERING BOARD MOUNT! STEP 7 Install Projector (Requires 4/6 screws depending on projector) ...
- Page 6 Pro-LIFT G4U WM Assembly Sheet Board Mount Board Mount Wall Mount Leg Safety Cable L L Wall Mount Leg Bottom Wall Mount Leg Wall Mount Leg L L Pencil Tray Mount Plates ...
Need help?
Do you have a question about the G4U-WM and is the answer not in the manual?
Questions and answers