Calculate The Cycle Time And Soak Time Settings; Rapidly Delete All Messages On The Controller - Baseline BaseStation 3200 Manual

Calculate the Cycle Time and Soak Time Settings

When you are configuring zone watering times and
soak cycles (controller dial is on Zones), you can let
the controller calculate the cycle time and soak time
settings for you. Enter the total run time in the
Water Time field. Press the Next button to move to
the minutes placeholder in the Soak Time field, and
then press the Back button. The controller divides
the time in the Water Time field by 3. This value is
used for the cycle time and the default soak time is
double the cycle time.
If you want to change the values in the Cycle Time
and Soak Time fields to the controller-calculated
values, press the Next button to move to the minutes
placeholder in the Soak Time field, and then press
the Back button. The values change to zeroes. Press
the Back button again and the controller-calculated
values display in the fields.

Rapidly Delete All Messages on the Controller

To rapidly delete all messages on the controller:
1. Turn the dial to Messages.
2. Press Next to select Delete.
3. Press and hold Enter until the controller
shows that all the messages have been
deleted.
Select an Item in the Left Column when the Cursor is in the Right Column
In screens with a two-column layout, such as the one
illustrated here, you can select an item in the left
column when the cursor is in the right column.
Press Enter as needed to select the item in the left
column, and then press + or – to make the
assignment in the right column.
Baseline Support: 866-294-5847
BaseStation 3200 Irrigation Controller Shortcuts
2 www.baselinesystems.com