Panasonic LC2H Manual page 8

2 Installation frame type
1. Remove the battery cover 1 from the
case.
2. Remove the battery 2 from the side of
the case. The battery will come loose if
you put the battery side face down and
lightly shake the unit
3. Before inserting wipe clean the surface
of the battery.
4. Insert the battery with the + and – sides
in the proper position.
5. After replacing the battery return the
battery cover to the case 5. Verify that the
hook of the battery cover is properly en-
gaged.
6. Before using press the reset button 6
on the front.
Options
1. Accessaries
Panel cover (black)
Part No.: AEL3801
You can change the design of the front
panel by replacing it with this black panel
cover. The counter comes with an ash
gray panel cover as standard.
1
2
+ side
5
− side
2. Lithium battery (3 V)
Part No.: ATH3802
Comes packaged with the LC2H (exclud-
ing the PC board mounting type).
Warning
• Make sure the + and − polarities are
positioned correctly.
• Do not throw the old battery into a fire,
short circuit it, take it apart, or allow it to
come into contact with heat.
• The battery is not rechargeable.
02/2003
6
3. Installation parts
Mounting bracket (suitable for installa-
tion frame type)
Part No.: ATH3803
Packaged with LC2H (panel mounting
type installation frame type).
Rubber gasket (suitable for installation
frame type)
Part No.: ATH3804
Packaged with LC2H (panel mounting
type installation frame type).
LC2H
75