Advertisement
Calibration & Sound
Calibration coordinates the position of the pen with the
location of your cursor. If the pen position and cursor
location don't match, you can perform auto calibration, or
you can calibrate manually for even greater accuracy. You
don't need a computer, and you won't need to calibrate
again unless the projector or image is moved, or the
image is resized.
1
To start pen calibration, press the User button on
the remote control, or press the Home button on the
remote control and select Auto Calibration.
2
When you see the Auto Calibration screen, do one of
the following:
• Press
to run auto calibration, then wait until
calibration is complete.
• Select No, then press
below to calibrate manually.
3
Select Manual Calibration, then press
4
When you see the Manual Calibration screen, press
to select Yes.
5
Touch the center of the circles on the screen with
your pen to perform manual calibration.
Sound
With the HDMI cable connected you will be able to
control sound through the projector from your
computer.
If sound is only coming from your computer follow
these steps:
o Open System Preferences by clicking the apple
icon in the top left corner of your screen
o Select Sound
o Select Output
o Choose HDMI
You may need to repeat these steps when using a
new projector.
and follow the steps
.
EPSON is a registered trademark and EPSON Exceed Your Vision is a registered
logomark of Seiko Epson Corporation. BrightLink and PrivateLine are registered
trademarks of Epson America, Inc.
Mac is a trademark of Apple Inc., registered in the U.S. and other countries.
General Notice: Other product names used herein are for identification purposes
only and may be trademarks of their respective owners. Epson disclaims any and
all rights in those marks.
This information is subject to change without notice.
© 2016 Epson America, Inc., 9/16
Printed in XXXXXX
CPD-50682
Advertisement
