GEMEITA Laminator User Manual page 5

DANGER
*Check whether the voltage specification of the device matches that of your
electricity network (220 - 240 V, 50/60 Hz).
*If you have used the laminator for hot lamination shortly before, you must let
the laminator cool down. The cooling time takes up to 15 minutes.
*To avoid folding the laminating pouch, the open side of the laminating pouch
must never be inserted into the insertion slot of the laminator first. When
inserting the pouch, please follow the instructions on the insertion slot. The
lamination process is automatic.
Using the laminating pouch
♦ Please choose the correct size of the laminating pouch according to the document. The
laminating pouch size includes A4 (220x310 mm), A5 (225x160 mm) and photo size
(160x110 mm).
♦ Only use laminating pouches of the correct size (up to A4) and thickness (80 to 125 mic).
Laminating pouches that are too thin may cause blockage inside the device.
♦ The laminating pouch has sealed on one side. Open the laminating pouch and place
the document to be laminated centrally in the pouch.
♦ Have the laminating pouch held 2-6 mm away from the edge of the laminator.
♦ Please put the sealed side of the laminating pouch (not the open side) in the entrance
to start lamination.
Sealed Edge
Figure 1
Figure 3
Figure 2
Figure 4
-06-
Note: Please avoid the following situations.
1. Cut the laminating 2. Insert from the open
pouch
4. Inconsistent file size
Using the paper cutter
The laminator is equipped with a sharp and safe paper cutter that has precise grid
lines for effortless cutting. Cut documents, photos, images in any (desired) size.
1. Open the transparent plate, place the document in the paper cutter, align the position
and cover the transparent plate.
2. Fix the transparent plate and document with one hand, and hold the blade and pull or
push it to the end with the other hand.
3. Please clean the debris in the paper cutter before cutting again.
3. Splicing the
side laminating pouch
5. Curled files
-07-