Names Of Components; Hot Lamination; Cold Lamination - GEMEITA Laminator User Manual

Names of components

Entrance
Corner rounder
Paper cutter
-04-
ABS switch
(Jam release switch)
Exit
Function key
(on/off switch)

Hot lamination

1. Plug the power cord into an easily accessible standard electrical outlet.
2. Turn on the on/off switch to position II: "HOT" , and the red indicator lamp lights up.
3. The drive motor for the transport rollers starts up. After about 3-5 minutes, the
operating temperature is reached and the green indicator lamp lights up.
4. Put the item to be laminated into the laminating pouch, keeping a distance of about 2-6
mm on all sides of the pouch edge.
5. Insert them together into the insertion slot of the laminator. The closed side of the
laminating pouch must be inserted first.
DANGER
*Check whether the voltage specification of the device matches that of your
electricity network (AC 220 - 240 V, 50/60 Hz).
*Use only hot laminating pouches.
*To avoid folding the laminating pouch, the open side of the laminating pouch
must never be inserted into the insertion slot of the laminator first. When
inserting the pouch, please follow the instructions on the insertion slot. The
lamination process is automatic.
*The emerging laminating pouch is very hot and soft after lamination.
Therefore, please handle the laminated item carefully.
*For leveling, the laminated item can be pressed with a book or other heavy,
flat object.

Cold lamination

1. Plug the power cord into an easily accessible standard electrical outlet.
2. Turn on the on/off switch to position I: "COLD" .
3. The drive motor for the transport rollers starts up, and the green indicator lamp lights
up.
4. Remove the protective film from the laminating pouch.
5. Put the item to be laminated into the laminating pouch, keeping a distance of about 2-3
mm on all sides of the pouch edge.
6. Insert them together into the insertion slot of the laminator. The closed side of the
laminating pouch must be inserted first.
-05-