Lan - Planet Networking & Communication WDRT-730 User Manual

SSID
Channel Number
Wireless Band
Site Survey
Encryption
5.2.3

LAN

There are two ways to assign IP addresses to computers: Static IP Address (set the IP address for
every computer manually), and Dynamic IP Address (IP address of computers will be assigned by a
router automatically). It is recommended for most of computers to use dynamic IP address, because it
will save a lot of time on setting IP addresses for every computer, especially when there are a lot of
computers in the network; for servers and network devices which will provide services to other
computers and users that come from Internet, static IP address should be useful, so other computes
are able to locate the server. You can configure the IP parameters of the LAN on the screen as below.
only as a wireless client to connect to the wireless network of the local
ISP for Internet connection.
Input the name of wireless network here that your wireless ISP provide
to you.
This is the radio frequency used to transmit and receive the wireless
signal. Select the channel designated by your wireless ISP.
Check either 2.4GHz or 5GHz wireless band is provided for the
network by your wireless ISP.
Click 'Site Survey' button, then a "Wireless Site Survey" table will pop
up. It will list all available access points nearby. Select the access point
designated by your wireless ISP in the table and the router will join
wireless network through this access point.
If the wireless ISP enables wireless security, you have to follow the
same settings in order to access its access point. Select the
corresponding encryption method for this connection (Please refer to
the Chapter 5.2.4.3 Security Settings for the detailed instructions).
Table 5-10
-36-
User Manual of WDRT-730