Pppoe - Planet Networking & Communication WDRT-730 User Manual

Object
IP Address
Subnet Mask
Default Gateway
TTL
5.2.2.3.

PPPoE

If your local ISP provides a PPPoE connection, choose PPPoE and fill the necessary parameters
below. (Figure 5-11):
Object
User Name / Password
Service Name
MTU
Connect Type
Enter the IP address in dotted-decimal notation provided by your ISP.
Enter the subnet Mask in dotted-decimal notation provided by your
ISP, usually is 255.255.255.0
(Optional) Enter the gateway IP address in dotted-decimal notation
provided by your ISP.
Choose the number of TTL if the local ISP requires you to do so.
Table 5-4
Figure 5-11 WAN – PPPoE
Enter the User Name and Password provided by your ISP. These fields
are case-sensitive.
Please give a name to this Internet service.
(Optional)
Please input the MTU value of your network connection here. If you
don't know, please keep the default value.
You can select Continuous to keep the connection be always on. Or
select Connect on Demand, then you can configure Idle Time Out
-28-
User Manual of WDRT-730
Description
Description