DAVIDSEN 623293 Instruction Manual page 27

Mounting
- Two people are required to mount the
awning.
- The awning should form an angle of
about 80 degrees in relation to the wall
when it is extended. The mounting
height should be calculated as the
desired height of the outermost point of
the awning (A) plus 0.17 × the awning's
drop (here 0.17×250 cm = 43 cm).
- If instead you want an angle of 60° in
relation to the wall, replace the constant
of 0.17 in the calculation with 0.50 to
get the mounting height.
- If instead you want an angle of
maximum 45° in relation to the
wall, replace the constant of 0.17 in
the calculation with 0.71 to get the
mounting height.
- The distance between the brackets
(10) is shown in the illustration below
(shown in mm).
- Drill holes for the wall brackets in the
wall using the relevant distances and
the desired mounting height.
1 3
2
9
-
-
-
6
5
4
bm bm
bl bl
C = A + 0.17 × H
The holes must be 12 mm in diameter,
and they must have the same depth as
the expansion bolts.
The holes in each group must be
vertically and horizontally aligned.
Note: Mark up the lines and drill holes
before you drill to ensure you are
accurate.
8
DK
NO
SE
FI
GB
DE
ET
7
27