Technical Data; Special Safety Instructions; Main Components - DAVIDSEN 623293 Instruction Manual

AWNING 3.5×2.5 M
Introduction
To get the most out of your new awning,
please read through these instructions
before use. Please also save the instructions
in case you need to refer to them at a later
date.

Technical data

GB
Canvas:
Enclosure:
Frame:
Incline:
Max. wind speed:
Dimensions:
Colour, model 623293:
Colour, model 623294:

Special safety instructions

- The awning is designed to provide
shade from the sun. It is not suitable as
rain protection.
- The awning must not be unrolled if the
wind is blowing more than 10 m/s.
- Always roll the awning up when not in
use.
- The awning must not be used in
temperatures below 0 degrees Celsius.
26
280 g/m 2 polyester
Semi-cassette
Powder-coated
0-45°
10 m/s
350×250 cm
Grey/grey
Grey/taupe
- The awning must not be used if its
mechanical parts are not working
correctly.
- Make sure that the mounting point can
handle the weight of the awning.
- Do not hang anything on the awning
frame.
- Do not place a lit barbecue or other
heat source or naked fl ames under the
awning.
- The awning fabric must be taut when
unrolled.
- The fabric must not be wet when rolled
up.
- Note! If you mount the awning
anywhere other than a wall (made of
brick, concrete, porous concrete, etc.),
you must buy screws suitable for the
material at the mounting point!

Main components

1. End piece
2. Interchange
3. Arm joint
4. Arm
5. Inner cross bar (square)
6. Roller
7. Canvas
8. Front cross bar
9. Hand crank
10. Mounting
11. Expansion bolts