Advertisement
SIGN CONFIGURATION – MASTER ONLY
The ML+ is designed to operate as an independent unit (MASTER ONLY), or operate two
ML+ units (MASTER/ SLAVE) controlled by a single remote control. Follow the instructions in
this section to operate the ML+ as a MASTER ONLY configuration.
1) Locate the MASTER INPUT and OUTPUT1 ports on the back, left side of the ML+
MASTER ML+ (Backside)
2) Using the supplied Data Cable, connect as shown below.
3) Secure the connections by tightening the fasteners or screws.
Go to SIGN INSTALLATION section for completion
OR
Continue to next section for MASTER/SLAVE Configuration.
Page 2
Advertisement
