Proctor-Silex 51151 Manual page 3

personal injury and/or damage to the blender (attachments may not be
provided with blender). A rubber spatula may be used but only when
blender is not running.
14. Blades are sharp; handle carefully—especially when assembling,
disassembling, or cleaning inside blender jar.
15. Do not use a broken, chipped, or cracked blender jar.
16. Do not use broken, cracked, or loose cutting blade assembly.
17. To reduce the risk of injury, never place cutting blade assembly on
base without jar properly attached.
18. Always operate blender with lid in place.
19. Do not blend hot liquids.
20. Ensure collar on base of blending jar is tight and secure. Injury can
result if moving blades accidentally become exposed.
21. If the jar should twist or rotate when motor is switched ON, switch
OFF ( ) immediately and tighten jar in collar or on blender base.
22. Do not leave blender unattended while it is operating.
23. Check that the appliance is OFF ( ) before plugging cord into wall
outlet. To disconnect, turn the control to OFF
( ); then remove plug from wall outlet. To unplug, grasp the plug and
pull from the outlet. Never pull from the power cord.
24. Do not use appliance for other than intended purpose.
25. CAUTION! In order to avoid a hazard due to inadvertent resetting of
the thermal cut-out, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.
SAVE THESE INSTRUCTIONS
3