Table of Contents
Advertisement
The following options are available:
•
ZONE 2 – The output is used as a regular zone output.
•
PANIC – The output reacts to panic transmissions from 1-button keyfobs or SOS
transmissions from 4-button keyfobs - see Figure 7: Keyfob Button Assignments.
4. Press SELECT.
3.1.2 LCD Configuration
You can configure the LCD display to be enabled or disabled during normal operation. When disabled,
the LCD shall still operate during Programming mode.
To configure the LCD display:
1. In Configuration mode, press SELECT and then
2. Press SELECT and then
3. Press SELECT.
3.1.3 Re-Synchronization
When a transmitter is out-of-synch, its transmissions are rejected by the system and you need to re-
synchronize the transmitter.
To re-synchronize a transmitter:
1. In Configuration mode, press SELECT and then
2. Press SELECT; RESYNC, OK?; appears on the display.
3. Press SELECT; a 10-minute time window opens.
4. During the 10-minute window, if a transmission is received that is out of synchronization, the
transmitter is re-synchronized.
3.1.4 Jamming
When Jamming is enabled, the receiver is able to detect the presence of continued RF interference
that may disrupt the reception of real transmissions from registered devices. You can set jamming
detection to either US or European standards or disable jamming detection altogether.
To configure the Jamming setting:
1. In Configuration mode, press SELECT and then
2. Press SELECT and then
3. Press SELECT.
3.1.5 Supervision Time
The supervision time is the period after which the transmitter is considered as "inactive" if no
transmissions are received.
To set the supervision time:
1. In Configuration mode, press SELECT and then
2. Press SELECT; SV TIME, XXh appears on the display.
3. Use
and
to choose a time between 2 and 24 hours in 1 hour increments.
4. Press SELECT.
3.2 Registering and Deleting Transmitters
Transmitter registration enables the receiver to recognize the source of received transmissions. Once
the receiver is installed, up to 8 individual detection devices can be registered, one to each output. In
addition you can register up to 16 keyfobs at the expense of detection devices registered to zones 1 and
2 (i.e. if you are using zone outputs 1 and 2 for keyfobs, you can register up to six detection devices to
the remaining zones).
or
to enable or disable the LCD.
or
to configure the jamming EU, US or Disabled.
-9-
or ; CONFIG, LCD appears on the display.
or ; CONFIG, RESYNC appears on the display.
or ; CONFIG, JAMMING appears on the display.
or ; CONFIG, SV TIME appears on the display.
Advertisement
Table of Contents
